![]() ![]() Specifies whether the host target communication link can be used for simultaneous send and receive. If you get a timeout error after program download, increase this value. ![]() Especially with compressed entities, the required time may vary significantly depending on program size, target processing speed, etc. After downloading, RTRun or the debugger have to wait until the program has initialized. Timeout value to apply for program initialization in milliseconds. In some cases, the default timeout could be unsuitable (e.g, cross debugging over the Internet with long round-trip times, etc). A default timeout is calculated depending on the port type, baudrate, etc. Timeout value to apply for host - target communication in milliseconds. Merely for pipes, a smaller value may be tried if communication is unreliable. The maximum supported value of 2048 for serial and parallel ports and 1460 for Ethernet should generally be used. Maximum number of bytes the host may send to the target before waiting for an acknowledge packet. If the host target communication is unreliable, try using a lower value. If both host and target have buffered UARTs, it should not be necessary to use a baud rate lower than 115200. The value specified must match the value given in Monitor's configuration file. Speed of host target communication if serial ports are used. The default port address used is 0x378 for LPT1, 0x278 for LPT2, and 0x3BC for LPT3. For parallel ports, it is only required if your port uses a non-standard port address. This value is ignored for serial ports and Ethernet. If no IP address is given, the host debugger will search the local LAN segment for targets and prompt for each found if the debugger should connect to it.ĭecimal port I/O address of the parallel port specified in the Port setting. For cross debugging over Ethernet, value IP optionally followed by the IP address or DNS host name of the target should be entered. A pipe name may be used if the target is a virtual target of a PC software emulator which supports emulated serial I/O over a pipe (e.g. If an LPT port is selected, you must look up the port's I/O address in the Windows Device Manager and supply this value in IOBase (see below). LPT ports are not supported under 64-bit versions of Windows. Any COM port as well as LPT1, LPT2, and LPT3 are supported. Serial port, parallel port, pipe name (e.g., \\.\pipe\vcom), or IP address used by the host to communicate with the target. Each section starts with a section name in square brackets, followed by keywords and their respective values. Rttarget.ini is an ASCII text file divided into sections. In addition, options for the debugger can be specified in file Rttarget.ini. This information is read from file Rttarget.ini located in the default directory or RTTarget-32's Bin directory. The cross debugger and download utility RTRun must know how to communicate with the target computer. Redistributable Components of RTTarget-32 Compiling and Linking with On Time RTOS-32 ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |